spare key

Motocod · Post by **Motocod** » Fri May 15, 2015 9:36 am

For the life of me I don't know where my spare key is, so looking at getting one cut, using one of these:

http://www.ebay.co.uk/itm/key-blank-sui ... 25a5bbb6fd

Silly question perhaps, but I assume there is no chip or anything daft like that in the key?

Nik

Blackal · Post by **Blackal** » Fri May 15, 2015 10:25 am

There is in my 2004 R1100s.

Al

Motocod · Post by **Motocod** » Fri May 15, 2015 12:17 pm

Mine's a 53 plate, if that makes any difference?

Dog Tyred · Post by **Dog Tyred** » Fri May 15, 2015 1:25 pm

Don't think there is in my 02 BCR as one of the spare keys is just a metal key, with no rubber bit.

The main two keys look just like the one in the above link.

DT

dave the german · Post by **dave the german** » Fri May 15, 2015 3:45 pm

My spare key on my 04 BCR is just a metal key and 1 of the rubber fobs on another key was destroyed to put it into a Datatool fob so no chips on mine

Tapio · Post by **Tapio** » Sat May 16, 2015 9:41 am

Blackal wrote:There is in my 2004 R1100s.

Al

Do you have some kind of aftermarket device on your bike? what does it do?
There's no mention of an immobilizer or anything in the 2004 owner's manual.

Blackal · Post by **Blackal** » Sat May 16, 2015 11:03 am

I'm just going on the assumption that it appeared impossible (after several attempts) to get a normal key cut, which would operate the ignition.

But - unless it shows on the wiring diagram, then I think you can safely say that I have thrown you a "wobbly ball"

Al

Motocod · Post by **Motocod** » Sun Jun 21, 2015 4:46 pm

Just to follow up on this, I purchased the above and had it cut locally, and it works fine.