Page 1 of 1
spare key
Posted: Fri May 15, 2015 9:36 am
by Motocod
For the life of me I don't know where my spare key is, so looking at getting one cut, using one of these:
http://www.ebay.co.uk/itm/key-blank-sui ... 25a5bbb6fd
Silly question perhaps, but I assume there is no chip or anything daft like that in the key?
Nik
Posted: Fri May 15, 2015 10:25 am
by Blackal
There is in my 2004 R1100s.
Al
Posted: Fri May 15, 2015 12:17 pm
by Motocod
Mine's a 53 plate, if that makes any difference?
Posted: Fri May 15, 2015 1:25 pm
by Dog Tyred
Don't think there is in my 02 BCR as one of the spare keys is just a metal key, with no rubber bit.
The main two keys look just like the one in the above link.
DT
Posted: Fri May 15, 2015 3:45 pm
by dave the german
My spare key on my 04 BCR is just a metal key and 1 of the rubber fobs on another key was destroyed to put it into a Datatool fob so no chips on mine
Posted: Sat May 16, 2015 9:41 am
by Tapio
Blackal wrote:There is in my 2004 R1100s.
Al
Do you have some kind of aftermarket device on your bike? what does it do?
There's no mention of an immobilizer or anything in the 2004 owner's manual.
Posted: Sat May 16, 2015 11:03 am
by Blackal
I'm just going on the assumption that it appeared impossible (after several attempts) to get a normal key cut, which would operate the ignition.
But - unless it shows on the wiring diagram, then I think you can safely say that I have thrown you a "wobbly ball"
Al
Posted: Sun Jun 21, 2015 4:46 pm
by Motocod
Just to follow up on this, I purchased the above and had it cut locally, and it works fine.