New member

f90x · Post by **f90x** » Wed Jul 01, 2015 7:16 pm

Blackal wrote:
f90x wrote:Congrats on your choice of the Zard BTW. Without doubt the best looking tail pipe for the 12S
Ahem............

Just sayin'...........

Al

and there's the evidence. Like I said. He chose the best looking pipe

Gooner · Post by **Gooner** » Wed Jul 01, 2015 8:19 pm

Help, Been winding these bolts for ages, they've come out so far about half an inch and now they just seem to keep turning. You can see the end of the bolt head turning on top of the system.

What do they screw into

Boxermed69 · Post by **Boxermed69** » Wed Jul 01, 2015 9:43 pm

f90x wrote:
Blackal wrote:
f90x wrote:Congrats on your choice of the Zard BTW. Without doubt the best looking tail pipe for the 12S
Ahem............

Just sayin'...........

Al
and there's the evidence. Like I said. He chose the best looking pipe

The Zard does look good, but I'm with Al - the Akra is super-sexy

Mike

exoticices · Post by **exoticices** » Wed Jul 01, 2015 9:59 pm

Gooner wrote:Help, Been winding these bolts for ages, they've come out so far about half an inch and now they just seem to keep turning. You can see the end of the bolt head turning on top of the system.

What do they screw into

They go into a sort of rubber gromit.
When they "seem to keep turning" you should be able to just pull them out.

f90x · Post by **f90x** » Wed Jul 01, 2015 10:58 pm

Boxermed69 wrote:
f90x wrote:
Blackal wrote: Ahem............

Just sayin'...........

Al
.

and there's the evidence. Like I said. He chose the best looking pipe
The Zard does look good, but I'm with Al - the Akra is super-sexy

Mike

Yes, you would say that with your

stevie wonder glasses on

f90x · Post by **f90x** » Wed Jul 01, 2015 11:00 pm

exoticices wrote:
Gooner wrote:Help, Been winding these bolts for ages, they've come out so far about half an inch and now they just seem to keep turning. You can see the end of the bolt head turning on top of the system.

What do they screw into

They go into a sort of rubber gromit.
When they "seem to keep turning" you should be able to just pull them out.

Yes, they are somewhat of a bitch to get out. I used a pair of pliers or other lever to push them away from the frame whilst simultaneously continuing to turn them with the ratchet.

When you put them back in, having someone push against he end of the pipe isn't a bad idea either.