www.boxertrix.com

Seeking advice on CF alteration. Can CF be worked with? My hugger is hitting the cat bypass, was wondering if I could cut a section out of the hugger. If that is possible, will the edges need to be sealed after making the cut?
Thanks.
D Man

D Man wrote:Seeking advice on CF alteration. Can CF be worked with? My hugger is hitting the cat bypass, was wondering if I could cut a section out of the hugger. If that is possible, will the edges need to be sealed after making the cut?
Thanks.
D Man

Mr sandbar would be the person to ask, hell be along soon I would think

Hi D Man,

I cut a corner out of my Ilmberger hugger a few years back with no problem. Had to do it as with the Staintunes double pipes there was no room.

Andrew

D Man wrote:Can CF be worked with? My hugger is hitting the cat bypass, was wondering if I could cut a section out of the hugger. If that is possible, will the edges need to be sealed after making the cut?

Yes you can. Use a Dremel or similar. If you need to remove a lot, then use a face mask because of the carbon dust.

Make sure that you are only removing part of the carbon fibre and not part of the support system.

There is no need to seal the edges - it will not corrode. After all, most other manufacturers do not do any sealing or coating at all. If you want to put something on the edge, then the cheapest way is to use clear nail varnish.

sandbar

Thanks to you all for responding, big help!
D Man