popping back and exhaust emissions queery
Posted: Thu Dec 14, 2006 11:28 pm
Hi there
I have an 03 1100s with a Y piece and standard exhaust/ lambda etc. It runs sweetly but seems to pop back a lot on over-run.
Have measured the emissions on a 4 gas analyser and they are;
high for Oxygen (7%)
low for CO2 (9%)
CO is fine (0.3%)
HC is fine (45ppm)
I cant find any air leaks in the inlet or exhaust and reckon that the exhaust gas flow thru the tail pipes at idle is too low to give a sensible reading. Has anyone else run a similar set up on a 4 gas analyser or have any comments ?
Cheers folks
Colin
I have an 03 1100s with a Y piece and standard exhaust/ lambda etc. It runs sweetly but seems to pop back a lot on over-run.
Have measured the emissions on a 4 gas analyser and they are;
high for Oxygen (7%)
low for CO2 (9%)
CO is fine (0.3%)
HC is fine (45ppm)
I cant find any air leaks in the inlet or exhaust and reckon that the exhaust gas flow thru the tail pipes at idle is too low to give a sensible reading. Has anyone else run a similar set up on a 4 gas analyser or have any comments ?
Cheers folks
Colin