Page 1 of 1
Rear Caliper mounting bolt - Helicoil (r1100s)
Posted: Tue May 02, 2017 10:23 am
by Crazy Kev
Would anyone know the correct size Helicoil kit for the rear caliper mounting bolts Holes on a r1100s
Thanks Kev
Re: Rear Caliper Helicoil (r1100s)
Posted: Tue May 02, 2017 12:26 pm
by SP250
Depends on which thread is stripped.
Mounting, bleed nipple, hydraulic banjo fitting, or splitting the caliper halves if you have that type of caliper?
Re: Rear Caliper Helicoil (r1100s)
Posted: Tue May 02, 2017 2:22 pm
by dave the german
If it's the mounting I think it's a M8- I can check tomorrow when I'm off as I have a mounting plate off the bike. If it is, maybe go for the Wurth insert - looks to be a better bet for brakes
Re: Rear Caliper Helicoil (r1100s)
Posted: Tue May 02, 2017 9:21 pm
by Crazy Kev
Crazy Kev wrote:Would anyone know the correct size Helicoil kit for the rear caliper mounting bolts on a r1100s
Thanks Kev
Re: Rear Caliper mounting bolt - Helicoil (r1100s)
Posted: Thu May 04, 2017 10:12 pm
by nab 301
M10 x 1.5 on my '99 version . Or enter your bikes details on this site and the bolt sizes are listed in the descriptions.
http://www.maxbmwmotorcycles.com/fiche/PartsFiche.aspx
Re: Rear Caliper mounting bolt - Helicoil (r1100s)
Posted: Fri May 05, 2017 6:10 pm
by dave the german
yep I think you're right is an M10