Page 1 of 1

Rear Bungee brackets for R11S ?

Posted: Thu Jul 24, 2014 8:51 pm
by kfrogzx7
I'm looking for the bungee brackets that are standard on the the R11S just behind and below the pillion seat.
Anyone who has fitted pannier rails would have removed them to fit the rails.
They come with "plates" under the brackets according to parts diagrams at www.maxbmwmotorcycles.com

The actual part nos. are :
Plate Left - 52 53 2 328 639,
Plate Right - 52 53 2 328 640,
Left Brkt - 52 53 2 328 561,
Right Brkt - 52 53 2 328 562,

I'd be grateful for any suggestions to source them ?
I've got a Wunderlich tail pack that straps to them but I bought my bike with pannier rails attached that I've now removed .

Posted: Thu Jul 24, 2014 9:49 pm
by metropolis2k
Have you tried the breakers like Motorworks and James Sherlock? They don't list them on their site but they both have 1100S models they're breaking so they might well have some.

Posted: Thu Jul 24, 2014 10:07 pm
by tanneman
http://www.maxbmwmotorcycles.com/fiche/ ... v=04282014

Item no 6 & 7

I have not seen that on an 11S before.

I'm sure your local dealer can order the parts.

Posted: Fri Jul 25, 2014 8:29 am
by metropolis2k
tanneman wrote:http://www.maxbmwmotorcycles.com/fiche/DiagramsMid/B0002670.png?v=04282014

Item no 6 & 7

I have not seen that on an 11S before.

I'm sure your local dealer can order the parts.
I had them on my old 1100S (the grey/yellow one). Never knew what they were for! :lol:

Posted: Fri Jul 25, 2014 5:37 pm
by kfrogzx7
Yes, I'll probably enquire about ordering new, wonder what they'll cost !!
I've tried a couple of breakers , but they're not a common part , mostly they've been ditched for pannier rails or such.
I've also seen that as far as the Wunderlich tail pack is concerned I can thread a cable tie thru' the bolt holes and the loop makes a very satisfactory anchor point !!!
The Wunderlich is quite a nice piece of kit and will get used quite a bit I reckon.

Posted: Sat Aug 09, 2014 9:29 pm
by dave1100s
I am sure I still have all the bits and pieces that I removed from my 11s when I fitted the system panniers. I will have a look tomorrow, and if I can find them matey, you're welcome to them :D

Posted: Sun Aug 10, 2014 4:14 am
by dave the german
dave1100s wrote:I am sure I still have all the bits and pieces that I removed from my 11s when I fitted the system panniers. I will have a look tomorrow, and if I can find them matey, you're welcome to them :D
This is ONE of the things I love about this forum!!

Posted: Sun Aug 10, 2014 2:07 pm
by kfrogzx7
dave1100s wrote:I am sure I still have all the bits and pieces that I removed from my 11s when I fitted the system panniers. I will have a look tomorrow, and if I can find them matey, you're welcome to them :D
Thanks Dave , but I got them ( just fitted half hr ago actually ) from Cannon yesterday.
£27 .. but I must admit they do tidy up that "unfinished" looking gap behind the pillion pad when the pannier rails are off.
Thanks again anyway.

Posted: Mon Aug 11, 2014 8:43 pm
by dave1100s
kfrogzx7 wrote:
dave1100s wrote:I am sure I still have all the bits and pieces that I removed from my 11s when I fitted the system panniers. I will have a look tomorrow, and if I can find them matey, you're welcome to them :D
Thanks Dave , but I got them ( just fitted half hr ago actually ) from Cannon yesterday.
£27 .. but I must admit they do tidy up that "unfinished" looking gap behind the pillion pad when the pannier rails are off.
Thanks again anyway.
No problem mate, glad you got sorted :D