Page 1 of 1
Missing Post
Posted: Tue Sep 03, 2013 11:58 am
by The Teutonic Tangerine
I have lost a post: The post Where I asked about thje Bevel Box oil seal on an R1200 Bevel Box. I am still hoping someone can tell me how to remove the Black plastic annular (ring) cover as I don't want to fudge it.
Cheers
Posted: Tue Sep 03, 2013 12:17 pm
by Blackal
It got nuked..........
It developed into a big argument, then a flounce.
Al
Posted: Tue Sep 03, 2013 12:40 pm
by conkerman
Hehe.
Flounce.
I love that word.
Posted: Tue Sep 03, 2013 2:08 pm
by Corvus
Hee Hee. I'd forgotten that it all started with a genuine request! Was too busy dodging the muck n bullets.
Mainly muck.
Posted: Tue Sep 03, 2013 8:44 pm
by herrman
Hi,
Had to do this on my 12s last year, If I recall correctly the plastic (??) retaining ring just pops out with a small screwdriver, Destroy the old seal with a seal puller and pull out and drive the new seal in. I made a tool at work to push the new seal in --Short piece of 76mm pipe which I had to linish down slightly and away you go.
Peter.
Posted: Wed Sep 04, 2013 12:21 am
by boxerscott
There you go, experience and knowledge dispensed in a cordial and polite manner!
Posted: Wed Sep 04, 2013 7:13 am
by bikesnbones
boxerscott wrote:There you go, experience and knowledge dispensed in a cordial and polite manner!
Posted: Thu Sep 05, 2013 1:47 pm
by The Teutonic Tangerine
Thanks - by the time flouncing stopped so had the leak.