Ecu chip/tuning

RSBowling · Post by **RSBowling** » Sun Nov 06, 2016 7:54 pm

Hi,
I have a 1999 t reg 11s with a standard ecu, k&n filter, ypiece decat and standard end cans. I'm looking for a low cost chip or something along those lines.
I have contacted dynojet and a bloke on eBay selling EPROM chips, but neither have anything for me.
Reg is t82 mak and Chassis no is wb10422a0xza85756
Not after huge power, just let it loosen up a bit and utilise my small mods.
Any help/advice would be appreciated.
Many thanks,
Richard

Mitch1100 · Post by **Mitch1100** » Mon Nov 07, 2016 10:22 pm

Search Lennies sprockets

RSBowling · Post by **RSBowling** » Tue Nov 08, 2016 6:29 am

Funnily enough prior to posting this is been looking at them. Has anyone fitted these, and what do you think of them?
Cheers,
Richard

roadburner · Post by **roadburner** » Tue Nov 08, 2016 9:24 pm

I've got a spar John's chip lying around somewhere. But it's made for full system and bigger air filter. They're only about 50 pounds new though

RSBowling · Post by **RSBowling** » Wed Nov 09, 2016 6:53 am

How do you feel about the gains johns chip gives? Any compromises?
Cheers,
Richard

RSBowling · Post by **RSBowling** » Fri Nov 11, 2016 9:05 am

Sit rep.
Have been in communication with John regarding his chips. He has been so helpful, so I have bought one off him. Married up to suit the mods I have done.
Had to buy a new ecu but that's not too expensive.
Will post how it performs once fitted.
Rich

KTM AL · Post by **KTM AL** » Mon Nov 14, 2016 7:47 pm

Hi Rich
Why did you have to buy a new ECU?
I have a stage 10 chip off John which was his latest one.
I have K&N and a Y pipe. I found it runs very well with good mid range smooth power. Would have been nice to dyno it before and after .

RSBowling · Post by **RSBowling** » Mon Nov 14, 2016 8:23 pm

Hi Al,
I had to buy a new (second hand) ecu as my bike is fitted with a ecu from 99, 00 era which has a serial number 1 ******
I needed a ecu with serial number 7 ****** which is from a later single spark models.
I don't know exactly why, I sent a eBay link to John asking if it was suitable, and he said yes that's great!
Good to hear that the chip working for you. He sending me a stage 9 chip, off his recommendation. To be honest the bike runs great as it is, but after reading feedback on these chips, I thought while its winter and I'm dismantling the bike (paintwork and exhaust header removal!) I'd try this great value tuning mod.
Cheers,
Rich

KTM AL · Post by **KTM AL** » Wed Nov 23, 2016 9:55 am

Hi Rich
Have you fitted your chip yet ? How did you get on ?

RSBowling · Post by **RSBowling** » Wed Nov 23, 2016 12:49 pm

Hi al,
Chip arrived yesterday, fitted it to bike and fired it up. Ran well and seemed smoother. But the real test will be out on the open road. Hope to get out this weekend but weather here is shit.
He sent me a stage 10 chip which is the top one he does. My next full up will be shell v power, bike should respond to better fuel now.
I'll keep posted
Cheers,
Rich

KTM AL · Post by **KTM AL** » Wed Nov 23, 2016 1:14 pm

Hi Rich
Where are you as you did not fill in your location?

RSBowling · Post by **RSBowling** » Wed Nov 23, 2016 3:52 pm

Hi Al,
Forgot to do that, I'll sort it later, and if I can figure it out I'll put a photo on!
I live in Durham, ride all over, in particular North Yorkshire.
Cheers,
Rich

RonB58 · Post by **RonB58** » Fri Nov 25, 2016 12:57 am

Hi Rich,
where exactly did you get the chip from? Couldnt figure it out though I can figure out you are Co Durham!

Cheers,

Ron

RSBowling · Post by **RSBowling** » Fri Nov 25, 2016 7:14 am

Hi Ron,
I got the chip on eBay, from a bloke called John. He lives in Greece, I just searched for johns chip, making sure you allow for search of worldwide items. Item number is 122182365960
Cheers,
Rich

bfisher · Post by **bfisher** » Sat Nov 26, 2016 7:53 am

Re ECU : i believe the early ones didn't have removable chips.

B