Gents,
(R1100S, 2001, iABS, 9,000 miles)
Stupid question: Has anyone found a sensible, stainless(?) alternative to those (2) bloody Self-Tapping Screws (p/n 13 711 342 959) attaching the intake air duct to the top of intake filter box please?
Intake Duct Self-Tapping Screws
Moderators: Gromit, Paul, slparry
Intake Duct Self-Tapping Screws
Never argue with a fool, bystanders can't tell who's who!
BMW's: R1100S, R1150GS, R1150RT, K1200RS
Suzuki DR650 RSEN
BMW's: R1100S, R1150GS, R1150RT, K1200RS
Suzuki DR650 RSEN
-
The Teutonic Tangerine
- Posts: 1646
- Joined: Mon Jan 28, 2008 3:18 pm
- Location: Essex
- Contact:
Drill out the holes, tap them and then screw in some studding then you can hold the lid on with nuts & washers. But I'd just carry on using the screws.
There would appear to be a surfeit of prolixity and sesquipedalian content today please do not use a big word when a singularly un-loquacious and diminutive linguistic expression will satisfactorily accomplish the contemporary necessity
TTT,
Thank you; however, I was hoping that someone had discovered an alternative 5 x 20 self-tapping screw - perhaps a hex-head one in stainless that didn't do the usual BMW trick of rounding if one even looked at it!
Anyone?
Thank you; however, I was hoping that someone had discovered an alternative 5 x 20 self-tapping screw - perhaps a hex-head one in stainless that didn't do the usual BMW trick of rounding if one even looked at it!
Anyone?
Never argue with a fool, bystanders can't tell who's who!
BMW's: R1100S, R1150GS, R1150RT, K1200RS
Suzuki DR650 RSEN
BMW's: R1100S, R1150GS, R1150RT, K1200RS
Suzuki DR650 RSEN
Who is online
Users browsing this forum: No registered users and 50 guests